fix(newcat): reject invalid narrow filter values
fix(icom): reject non-BCD G90 SWR meter replies
fix(elecraft): read K4 power in a single transaction
fix(rig): skip the settling wait in rig_open() when there is no rig port
fix(rig): send nothing of a Morse text emptied before it is taken
fix(rig): release the Morse queue when a text does not fit
fix(rig): create the Morse queue before its thread starts
fix(rig): tie asynchronous port reads to the reader thread's lifetime
fix(rig): leave nothing started when a handler thread fails to start
fix(iofunc): validate pipe creation before using descriptors
fix(rig): report pthread errors from return codes
fix(rigctld): return clock errors before formatting
Merge pull request #2221 from jbdubbs/backport-4.7/ft857-att-preamp
FT-857: add ATT/PREAMP level support via EEPROM
Merge pull request #2220 from jbdubbs/backport-4.7/ft857-pktfm-pktlsb
FT-857: add PKTFM and PKTLSB mode support
fix(newcat): reject invalid narrow filter values
G90: reject non-BCD SWR meter replies
fix(elecraft): read K4 power in a single transaction
Merge pull request #2222 from mikaelnousiainen/daemon-client-socket-fixes
tests: retry daemon startup on a fresh port
tests: add a stress test for daemon client sessions
daemons: close each client socket once
prm80: return the error of the final prompt wait of a transaction
prm80: keep the default shift when a channel is written several times
prm80: REV only with firmware V5.1+, get_channel fails without the list
prm80: REV acts on the channel reported by [E], refuse tiny offsets
prm80: keep the default shift on a round trip, fresh state for REV
prm80: keep the nominal frequency of reversed channels, refuse gaps
prm80: invalidate the frequency cache when the rig changes the frequency
prm80: fix channel programming and shift handling for firmware V5
fix(rig): send nothing of a Morse text emptied before it is taken
fix(rig): release the Morse queue when a text does not fit
fix(rig): create the Morse queue before its thread starts
fix(rigctld): close an unsubscribed stream in 100 ms, not 1 s
test(icom): expect the liveness probe after a refused VFO query
test(ic7760): send the scope span for CURR and TX to their receiver
test(ic7760): keep the shared caps intact after a refused 07 D2
test(icom): keep the fake rig reading frames it can be sent
feat(ic7760): expose the OVF indicator and three more switches
fix(ic7760): read back which of Main and Sub is selected
fix(icom): address the IC-7760 Main and Sub bands by name
build: initialise Winsock in the icom socket tests
fix(ic7760): let the voice memories be transmitted
build: ignore test programs missing from tests/.gitignore
feat(ic7760): advertise more of the attenuator range
feat(ic7760): advertise the select memory scan
feat(ic7760): support the spectrum scope
fix(ic7760): the lowest CI-V rate is 4800, not 300
fix(ic7760): the antenna command carries three bytes, not four
fix(ic7760): advertise dual watch and the CI-V transceive switch
fix(ic7760): drop the AGC OFF setting the rig rejects
fix(ic7760): drop the priority scan the rig does not have
fix(ic7760): advertise the tuning step the rig actually has
fix(ic7760): let the CW pitch keep its shared granularity
fix(ic7760): correct the AM minimum power on 6 m
fix(ic7760): add the missing 5 A point to the Id meter scale
fix(ic7760): P.AMP 1 has 12 dB of gain, not 10
fix(ic7760): make the DRIVE gain and DIGI-SEL controls visible
fix(ic7760): connect the backlight setting to a command
fix(ic7760): give the SSB data modes their own filter widths
fix(ic7760): correct the default IF filter widths
test(ic7760): name the CI-V guide revision the values come from
fix(ic7760): stop asking the rig whether it is switched on
fix(ic7760): stop advertising two controls the rig does not have
fix(ic7760): send the VOX delay to the right setting
test(netrigctl): remove the rigctld log of a retried start
fix(icom): decode a negative lower edge in scope waveform data
refactor(icom): name the VFO that RIG_VFO_TX selects
fix(icom): send scope settings for CURR to the selected receiver
refactor(icom): name the scope byte and drop the VFO-number macros
fix(icom): start the select memory scan with its own subcommand
fix(icom): send the antenna selection once, not twice
fix(elecraft): preserve K4 split data submodes
fix(elecraft): avoid invalid split-mode buffer appends
fix(icom): disable get_vfo only on a rig that lacks 07 D2
fix(rigctld): return clock errors before formatting
build(ci): cancel superseded pull request runs
build(codeql): skip the C build for Python analysis
build(ci): parallelize builds with four make jobs
fix(stream): propagate close errors after releasing stream resources
fix(stream): use checked frame geometry for gap filling
Merge pull request #2278 from dchristle/fix/stream-buffer-geometry
Merge branch 'master' into fix/stream-buffer-geometry
test(icom): close the fake rig's socket only after its thread ends
fix(rig): stop a refused get_vfo from erasing it for the whole model
fix(rig): let the tuner control program handle only the tuner
Merge pull request #2271 from dchristle/fix/stream-codec-publication
fix(stream): publish codec frames and accounting atomically
Merge pull request #2166 from GregerA/ft2000-agc-levels
Remove AGC levels comments in ft2000.c
rigs: yaesu: ft2000: declare AGC level support in rig_caps
Merge pull request #2290 from arekm/dev/async-fixes
fix(rig): tie asynchronous port reads to the reader thread's lifetime
fix(rig): leave nothing started when a handler thread fails to start
fix(iofunc): validate pipe creation before using descriptors
fix(rig): report pthread errors from return codes
Merge pull request #2291 from arekm/dev/rigctld-keepalive
fix(rigctld): count stream timeouts in milliseconds, not whole seconds
Merge pull request #2292 from arekm/dev/icom-network-tests