Property value's tooltip shows diffrent value? - Advanced Installer Community
Codename K
Posts: 479
Joined: Fri Jan 29, 2010 3:04 pm

Property value's tooltip shows diffrent value?

Hello,

I created a property value. Then I changed the value of it from the Table Editor. When I built the installer and run it, it shows the new value. But when you open Select a Property window in Advanced Installer, it shows the old value. How to change it?

:?:
K
Eusebiu
Posts: 4971
Joined: Wed Nov 14, 2012 2:04 pm

Re: Property value's tooltip shows diffrent value?

Hi,

I'm afraid that the changes made in the "Table Editor" page are not reflected in the other pages of the project. For more details about how these changes are applied, you can take a look on the "Using the Table Editor" article.

Best regards,
Eusebiu
Eusebiu Aria - Advanced Installer Team
Follow us: Twitter - Facebook - YouTube
Codename K
Posts: 479
Joined: Fri Jan 29, 2010 3:04 pm

Re: Property value's tooltip shows diffrent value?

How to change the property value? I mean change the value shown in the Select a Property window. It is also not in the Install Parameters page.
K
Eusebiu
Posts: 4971
Joined: Wed Nov 14, 2012 2:04 pm

Re: Property value's tooltip shows diffrent value?

Hi,

You should be able to see and change the value of a property in the "Install Parameters" page if you check the "Show properties with empty value or used in dialog controls" option from the bottom of the page.

Best regards,
Eusebiu
Eusebiu Aria - Advanced Installer Team
Follow us: Twitter - Facebook - YouTube
Codename K
Posts: 479
Joined: Fri Jan 29, 2010 3:04 pm

Re: Property value's tooltip shows diffrent value?

It worked. Thank you.
K
Eusebiu
Posts: 4971
Joined: Wed Nov 14, 2012 2:04 pm

Re: Property value's tooltip shows diffrent value?

You're welcome. I'm glad you got this working.

Best regards,
Eusebiu
Eusebiu Aria - Advanced Installer Team
Follow us: Twitter - Facebook - YouTube

Return to “Common Problems”