some problem with installer - Advanced Installer Community
alirezam
Posts: 1
Joined: Mon Nov 26, 2018 8:04 pm

some problem with installer

Hello

i use Advanced installer v15.3 for my software and have 2 problems, will be grateful if you answer me.

1: how can i define a condition rule for .Net Framework 4.5.2 which placed in prerequisties section in pre-install folder to just install on windows 7 x86 and x64 without restart?

2:i see a unstable situations on windows servers like 2019 editions and it's run installer after i finshed and windows restarted! what was this occur ?

thanks
Catalin
Posts: 7852
Joined: Wed Jun 13, 2018 7:49 am

Re: some problem with installer

Hello and welcome to our forums,
1: how can i define a condition rule for .Net Framework 4.5.2 which placed in prerequisites section in pre-install folder to just install on windows 7 x86 and x64 without restart?
In order to achieve this, you can proceed as it follows:

- Go to "Prerequisites" page and click on your prerequisite (.NET Framework 4.5.2)

- Go to "Install Conditions" tab.

- Under "Supported Windows Versions", expand both "64-bit Windows versions" and "32-bit Windows versions" and leave only "Windows 7 x64" and "Windows 7 x86" options selected.
2:i see a unstable situations on windows servers like 2019 editions and it's run installer after i finished and windows restarted! what was this occur ?
I am not sure why this happens. You can try to suppress the reboot by enabling the "Suppress all Reboots and Reboot prompts" option from "Install Parameters" page --> "Reboot Behavior".

Hope this helps.

Kind regards,
Catalin
Catalin Gheorghe - Advanced Installer Team
Follow us: Twitter - Facebook - YouTube

Return to “Common Problems”