Hi all,
I have a setup that creates a user and install a service run by that user.
I use properties to create user (username and password are with properties) and to create the service too (the same properties plus, in this case, the domain one, which is requested).
The setup shows a logon form where (all these properties are) I added one extra textfield to re-type the password.
Actually I create a new set of properties where I copy the textfields' ones at the "next" click event: that's the set of properties I will use for user and service credentials definition.
The run does go fine for the user creation (I can double check it by a simple runas dos command) but the service credentials are not good (in fact I get a problem of logon).
I then finally set again the logon credentials of the just created service (while the message box is still there) and then hit retry and it all goes fine too.
How can I get the actual password that is provided to the ServiceInstall procedure?
Thanks a lot in advance.
Silvio
FOLLOW US
Get the latest news in Application Packaging