I have an issue very similar to that discussed (and fixed) in this thread. My installer is quite complex but the failure point is always the same - if I attempt to create a user that is a member of groups also created by the installer then the installation aborts and rolls back, but does not remove the newly created user. If I then run the installer again (without changing anything) it succeeds (presumably because the user is already there). If I manually delete the user (after the installer has rolled back) it again fails. If If I do not place the user in any groups then the installation proceeds normally. This problem has only appeared since I upgraded to version 7.6.1 of AdvancedInstaller.
I worked through the solution/suggestions in the above thread but my installer sequence is correct as far as I can see - installation of groups is before installation of users. Is there anything else I should look for in the installation?
I can work around this by using a .NET custom action of my own to apply the group memberships later on in the install sequence, but I would prefer not to have to maintain custom code if I can help it. Is this a bug, or have I missed something (or is there an adjustment I have to make now I have upgraded to 7.6.1)?
K Morrison
FOLLOW US
Get the latest news in Application Packaging