Using Advanced Installer 6.9.1 to build MSIs that should install different "editions" of the same software. The editions are different because they have different content modules which support the same application. In the Installer project they have different product names but the same product version. If none of the products in the series are already installed then the MSI will install the software and the relevant data folders. If one or more of the products is already installed then the MSI should effectively add the new data directories - although it will also install the application.
If that doesn't make sense then imagine adding new issues of a magazine to a bound volume collection. Each issue has the ring binder and the content for that issue. If you onlya have one issue then you always have the binder. If you add new issues you just ignore the binder and add the new issue to the existing binder.
The MSI's are built using a skeleton template into which the new data files are added outside Advanced installer. The folder is added fresh to theAdvanced Installer project before building the MSI.
When I run one MSI after another I get the "Another version of this product is already installed" message. Is there an obvious floor in my logic? If there is then I can't see it!
Confused of Oxford
FOLLOW US
Get the latest news in Application Packaging