Failing installation after the system was deferred - Advanced Installer Community
nirs
Posts: 42
Joined: Wed Aug 13, 2014 2:46 pm

Failing installation after the system was deferred

Hi,

During my installation, after the system is deferred I install a service.
Due to a bug, the service installation not always fail, so I must check if the service is exist at the end of my installation.
If the service is "Not Found" I want to fail the installation.
The problem is that I need failing installation is being done by "Display error message" custom action. (see http://www.advancedinstaller.com/forums ... =2&t=28888), but that custom action can be executed only immediately.

What do you suggest?
How can I fail my installation at the end, if the service was not installed after the system was deferred?

Thanks.
Nir
Eusebiu
Posts: 4971
Joined: Wed Nov 14, 2012 2:04 pm

Re: Failing installation after the system was deferred

Hi Nir,

In order to achieve this you can use a VBS custom action, for example, as the one attached to the how to Abort the Install on message box response thread.

Best regards,
Eusebiu
Eusebiu Aria - Advanced Installer Team
Follow us: Twitter - Facebook - YouTube
nirs
Posts: 42
Joined: Wed Aug 13, 2014 2:46 pm

Re: Failing installation after the system was deferred

Thanks.

Is there a way to display error message when exit?

Right now when the installation fail it is pop-upping that there is a problem.
Can I edit that text?
nirs
Posts: 42
Joined: Wed Aug 13, 2014 2:46 pm

Re: Failing installation after the system was deferred

In addition, that exit always cause the installation to 'rollback' while the property DISABLEROLLBACK is set to 1

Return to “Common Problems”