Update not installing main application - Advanced Installer Community
mgerde
Posts: 2
Joined: Thu Sep 04, 2014 3:09 am

Update not installing main application

We've released V1 of an application that was installed with Advanced Installer. It also included the updater and we're now to the point of wanting to update to V2. We are currently running into two issues:

1. When launching the update check from within the app, the update is found, downloaded and goes through the install process. It correctly detects the app is running and prompts to close it. After selecting to close it, the installation seems to succeed, but the main application .exe is not installed nor launched. All the other files seem to be there including a new assembly that didn't exist in V1.
2. When installing the new installer over the top of an existing installation, it detects the app is running and says a reboot will be required. Continuing the installation and rebooting exhibits the same problem where the main .exe application is not installed.

Installing the V2 installer without V1 installed runs fine and launches the main application at the end as it should.

This seems like a fairly common use case so I'm sure I have some settings wrong. Please let me know what I can check to correct these issues.
Daniel
Posts: 8283
Joined: Mon Apr 02, 2012 1:11 pm
Contact: Website

Re: Update not installing main application

Hello,

I'm not sure why this happens. Can you please enable (in V2 project) the "Always overwrite existing file" option for the EXE file which is not installed and see if the behavior still persists? If so, can you please send us the .AIPs (project files) and a verbose log of the upgrade installation to support at advancedinstaller dot com so we can investigate them?

All the best,
Daniel
Daniel Radu - Advanced Installer Team
Follow us: Twitter - Facebook - YouTube

Return to “Common Problems”