Does Set Installer Property CA Support Operators? - Advanced Installer Community
sjeslis
Posts: 308
Joined: Mon Aug 22, 2011 11:40 pm
Contact: Website

Does Set Installer Property CA Support Operators?

Can I set an installer property based on the value of a few parameters? e.g.

Can I set the Value field to:

[PARAM1] & [PARAM2] & [PARAM3]

these params will either be "0", '1" or not existent.
Scott Jeslis
Senior Software Engineer
Cicero, Inc.
Daniel
Posts: 8283
Joined: Mon Apr 02, 2012 1:11 pm
Contact: Website

Re: Does Set Installer Property CA Support Operators?

Hello Scott,

If you want to set a property to a value including another property values, then this is possible. However, to make sure I fully understand your requirements, can you please give us more details about your scenario (maybe exemplify a bit)?

All the best,
Daniel
Daniel Radu - Advanced Installer Team
Follow us: Twitter - Facebook - YouTube
sjeslis
Posts: 308
Joined: Mon Aug 22, 2011 11:40 pm
Contact: Website

Re: Does Set Installer Property CA Support Operators?

Well I have 4 registry search global parameters for two product registry keys, say:

PARAM1, PARAM1_64, PARAM2, PARAM2_64

if ANY of these is set (via a registry search) it means "Product A" is installed.

instead of sending my merge module all 4 four of these I want to send the merge module one parameter, e.g. PRODUCT_A_INSTALLED = 1.

So I was going to create a Set Installer Property CA for PRODUCT_A_INSTALLED. Will setting its "Value" equal to:

PARAM1 & PARAM1_64 & PARAM2 & PARAM2_64

work?

I don't think the Search wizard will allow me to point all 4 registry searches at one variable?
Scott Jeslis
Senior Software Engineer
Cicero, Inc.
mihai.petcu
Posts: 3860
Joined: Thu Aug 05, 2010 8:01 am

Re: Does Set Installer Property CA Support Operators?

Hi Scott,

Try setting this in the condition field of the custom action instead:

Code: Select all

PARAM1 AND PARAM1_64 AND PARAM2 AND PARAM2_64
All the best,
Mihai
Mihai Petcu - Advanced Installer Team
Follow us: Twitter - Facebook - YouTube
sjeslis
Posts: 308
Joined: Mon Aug 22, 2011 11:40 pm
Contact: Website

Re: Does Set Installer Property CA Support Operators?

Yes and I ended up getting:

MSI (c) (DC:90) [14:25:04:846]: PROPERTY CHANGE: Modifying CXMY_CITRIX_SERVER property. Its current value is '0'. Its new value: ' AND AND AND 1'.
Scott Jeslis
Senior Software Engineer
Cicero, Inc.
sjeslis
Posts: 308
Joined: Mon Aug 22, 2011 11:40 pm
Contact: Website

Re: Does Set Installer Property CA Support Operators?

It would be cool if this work but as a workaround I made my PARAM checks part of the install/run condition:

(PARAM1 OR PARAM1_64 OR PARAM2 OR PARAM2_64)

and then set the property to "1"
Scott Jeslis
Senior Software Engineer
Cicero, Inc.

Return to “Common Problems”