Hello and welcome to our forums,
I tested the scenario but the repackage operation on a Hyper-V VM was successful. Can you please tell us if you installed Advanced Installer on your Windows 10 computer (which actually hosts the Hyper-V VM) or did you install Advanced Installer on the Hyper-V VM?
If AI is installed on your real machine and you want to perform the repackaging operation on your Hyper-V VM, then you should follow our
"Repackaging an existing installation in a Hyper-V virtual machine" tutorial steps. Also, please check our
"Repackaging in VMs" article and make sure all the requirements are fulfilled by your system.
If AI is installed on your Hyper-V VM, then you should follow the
"Repackaging an existing installation" tutorial.
Also, this may happen when the setup you want to repackage resides on a drive root of your host machine. When repackaging in VM the Repackager cannot handle the case when the repackaged setup resides on a drive root on host machine. This is a Repackager limitation. If this is the case, as a workaround, you should just move your setup into a subfolder of the drive root.
Let us know if this helped, otherwise please give us more details about the software configuration of your system (Windows version, architecture, system language for both real machine and VM).
Best regards,
Dan
FOLLOW US
Get the latest news in Application Packaging