Issue with scheduling custom actions in UI sequence - Advanced Installer Community
sbaird
Posts: 57
Joined: Tue Sep 01, 2015 2:08 pm

Issue with scheduling custom actions in UI sequence

I've run into an issue with scheduling/sequence numbers in the UI sequence. I have a number of custom actions which must run at the end of the UI sequence (after ProgressDlg and before ExecuteAction). ProgressDlg is 1280 and ExecuteAction is 1300. My custom actions start at 1281, but must go past 1300 due to the additional AI_DATA_SETTER actions. It seems that AI won't allow the sequence number on ExecuteAction to be bumped past 1300, and the remaining custom actions are set to 1301 and beyond, etc. I've tried setting ExecuteAction to a higher number in Table Editor, but that causes AI to crash when I move custom actions around in the Custom Actions view. Any suggestions?
Daniel
Posts: 8283
Joined: Mon Apr 02, 2012 1:11 pm
Contact: Website

Re: Issue with scheduling custom actions in UI sequence

Hello,

First of all I apologize for my delayed reply. It seems somehow your post was overlooked by our support team.

Please note that you should be able to increase the sequence number of the "ExecuteAction" action. I'm not sure why you encounter the related behavior. Can you please send us the .aip (project file) to support at advancedinstaller dot com so we can investigate its settings?

All the best,
Daniel
Daniel Radu - Advanced Installer Team
Follow us: Twitter - Facebook - YouTube
sbaird
Posts: 57
Joined: Tue Sep 01, 2015 2:08 pm

Re: Issue with scheduling custom actions in UI sequence

Thanks for your response. I actually figured out that if I choose to show the "ExecuteAction" standard action in the Custom Actions page, then move all of my custom actions before it, the tool will indeed schedule "ExecuteAction" higher than 1300. This just wasn't intuitive, IMHO, because there are no actions to be scheduled after it.

Return to “Common Problems”