Hello,
I am using AI 12.7.1. I have an installer that creates an exe. This install works fine. This Installer has a couple of dialogs that the user must interact with to configure the installation. This installer work fine. Now I am attempting to figure out how this installer can be run silently. In an effort to find a solution to do this I've created another installer (i.e. msi from an EXE) using the following link http://www.advancedinstaller.com/user-g ... o-msi.html. I can run the resulting .msi file from the command line and the installer works fine (it appears that the msi is calling the original exe installer and installing the software as expected). Here's the command that I am using:
C:\Temp>"Acuity 7.30 Setup.msi" /Lv C:\Temp\log1.out
Refer to attached log file "log1.out"
Now when I attempt to run the same msi installer but silently (i.e. /qn command line switch), the installer fails to install. Here's the command that I am using:
C:\Temp>"Acuity 7.30 Setup.msi" /qn /Lv C:\Temp\log2.out
Refer to attached log file "log2.out"
Looking at log2.out, line #231 I see the following error:
MSI (s) (A8:14) [15:59:30:477]: Product: Acuity 7.30 -- Error 1606. Could not access network location "".
What is causing this error?
The intent is that most of the time the installer will be run in non-silent mode (i.e. the user will interact with the Installer dialogs). However, we would like to be able to deploy silently by pushing the installation down to specific machines. When deploying silently, we want to bypass the dialogs (i.e. the Installer UI) and simply install Features (other msi installers) and our software.
Any suggestions would be greatly appreciated!
Thanks in advance,
Todd
FOLLOW US
Get the latest news in Application Packaging