Running build/compile - Advanced Installer Community
paul03034
Posts: 1
Joined: Tue Jun 26, 2018 6:26 pm

Running build/compile

Hello,
I ran the wizard with trial license and it packs up all the files and directories and the size is there and when I take setup file that I just created to test install it does all the steps.

I click shortcut and file not found. Of coarse, I go to folder it created and it is empty. Everything is empty, just folders. Is this part of trial, where you can't fully test even though it gives message evaluation use only?


I am lost. It takes time to build the file and install and space is used on thumb-drive / pen-drive that I use for transfer to test computer. It acts like all the other installers except it does not work.

Thanks for any insight on this!
Catalin
Posts: 7852
Joined: Wed Jun 13, 2018 7:49 am

Re: Running build/compile

Hello and welcome to our forums,

I have tried to reproduce your scenario, but I did not encounter any problems. I have created a setup using a trial version of Advanced Installer on a Virtual Machine and then imported it on Main Machine.
Is this part of trial, where you can't fully test even though it gives message evaluation use only?
No, this is not part of trial. During the trial period, you can use Advanced Installer at full power.

I am afraid that I don't fully understand your scenario. Can you please send us the .aip (project file) by e-mail at support at advancedinstaller dot com so we can investigate its settings and try to test it on a clean Virtual Machine ?

Also, here is an article which I think you may find useful : "Creating a Simple package"

Regards,
Catalin
Catalin Gheorghe - Advanced Installer Team
Follow us: Twitter - Facebook - YouTube

Return to “Common Problems”