cannot specify failure action execute after in milliseconds - Advanced Installer Community
thiagorizzo
Posts: 8
Joined: Tue Oct 24, 2017 5:31 pm

cannot specify failure action execute after in milliseconds

Hi,

I just read in documentation that I could specify execute after failure action in milliseconds:
Image

but when I tried it I could only specify in minutes:
Image

Is there anyway to specify 30 seconds?

Thanks, Thiago Rizzo.
Catalin
Posts: 7852
Joined: Wed Jun 13, 2018 7:49 am

Re: cannot specify failure action execute after in milliseconds

Hello Thiago,

I have tested it and you are right. The time to wait before performing the specified action is, indeed, in minutes, not in milliseconds. Unfortunately, there is no way you can set it to execute after 30 seconds, the minimum time to wait before performing the action being 1 minute.

Thanks for pointing this out, we will update our user guide in the near future.

Regards,
Catalin
Catalin Gheorghe - Advanced Installer Team
Follow us: Twitter - Facebook - YouTube
Catalin
Posts: 7852
Joined: Wed Jun 13, 2018 7:49 am

Re: cannot specify failure action execute after in milliseconds

You're always welcome, Thiago!
Catalin Gheorghe - Advanced Installer Team
Follow us: Twitter - Facebook - YouTube

Return to “Common Problems”