Hello,
Something weird is going on with our installer projects. We set Launch Condtions under Supported Operating Systems to exclude only Windows 2000. Then we discovered when our installer projects were updated by v10.6, that Windows 8.1 x86 was not enabled by default. But now, when we enable 8.1 x86, Windows 8.1 still refuses to install our software.
Because you excluded the
Windows 2000 from your installation package than the
32-bit Windows Versions hasn't been marked anymore. Because not all of its
children have the same state the
32-bit Windows Versions parent wasn't marked.
When you updated to the 10.6 version of Advanced Installer and also the
Windows 8.1 Operating System support was introduced in Advanced Installer, by default it hasn't been marked because its
parent wasn't been marked. This is the normal behavior.
Please notice that the
Windows 8.1 x64 Operating System was enabled by default because its
parent was enabled.
And 8.1 x86 continues to appear in NT exclusion lists with Windows 2000 in the project file, even when the check boxes are checked/unchecked in the AI GUI. Not sure what is going on here, but I think that the project conversion got confused when it added Windows 8.1 x86.
I'm not sure why you encountered this behavior. I've tested your scenario but I cannot replicate it.
Can you please send us the .AIP (project file) to
support at advancedinstaller dot comso we can investigate it? If it contains confidential information you can send us a small test project which replicate this behavior.
Best regards,
Dan
FOLLOW US
Get the latest news in Application Packaging